Deceleration and heating constrained footprint of shuttle vehicles

With increasing frequency in shuttle operation, it is of interest to have more than one or two landing fields within the boundary of the reachable area of the reentry vehicle. This boundary, called the footprint, depends on the aerodynamic characteristics of the vehicle and is severely restricted by the deceleration and heating constraints imposed upon the atmospheric reentry trajectory. This paper gives a general assessment of the footprint as a function of various deceleration and heating constraints. The difficulties in the computation of the three-dimensional reentry trajectories with optimal modulation in both the angle-of-attack and the bank angle are alleviated by the following devices: (a) nondimensionalizing of the equations of motion and use of the density as the altitude variable; (b) use of the classical integrals of the motion; (c) transformation of the adjoint variables into physical variables; and (d) spherical rotation of the coordinates.     

Temporal intensity fluctuations of Her X-1 around 100 sec time scales

Her X-1 has been observed with EXOSAT for one 35^d cycle between March 1 and April 5, 1984 at about 4 day intervals. During three observations, absorption dips were encountered showing fluctuations with time scales in the several hundred seconds range. The data are interpreted with a model where random superposition of absorbing blobs or inhomogeneous structures within the accretion disk, in the line of sight, cause these intensity variations. The calculations give a measure of the extent of the disk both in vertical and radial directions.     

Electron density models for the lower ionosphere

Probably the only reliable method of checking an electron density model below 70 km is to calculate from it what would be obtained by VLF or LF propagation over certain paths, and to compare the results with actual observations. This has been done for the IRI at various frequencies from 16 to 70 kHz; the results agree in places but differ substantially elsewhere. Previous models described by the author give satisfactory results and it is suggested that certain features of them might be incorporated with advantage in the IRI. In particular, it is impossible to get agreement with VLF propagation in all seasons by means of a model varying only with solar zenith angle, such as the IRI from 50–90 km.     

Ballooning perturbations in the inner magnetosphere of the Earth: Spectrum,stability and eigenmode analysis

We investigate the generation of ballooning perturbations in the inner magnetosphere of the Earth in the dipole model of the geomagnetic field taking into account ionospheric boundary conditions. The ionosphere is considered as a thin layer with finite conductivity. The eigenmode spectrum is discrete and consists of Alfvén, slow magnetosonic, flute and incompressible modes. Their interaction depends on ionospheric conductivity. The decay rate is small in noon and night sectors and large in dawn and dusk sectors. The lowest stability threshold α/γ ≈ 4.25 is determined by flute modes.     

Calibration techniques for magnetometers implementing on-board de-spinning algorithms

The Fluxgate Magnetometer experiments on-board the European Space Agency’s four spacecraft Cluster Mission have the capability to store sampled magnetic field vectors in the instrument memory, either as a full resolution ‘event capture’ or as spin-resolution vectors transformed into a non-spinning co-ordinate system (de-spun). The latter capability has ensured a dataset is available which extends the partial orbital coverage achieved during nominal operations in the first years of operation. The on-board de-spin is achieved using a Walsh function with Haar coefficients and allows for up to 27 h additional data per non-coverage interval. A number of commissioning orbits were used to verify the accuracy of data collected by the de-spin mode, whereby individual spacecraft were operated separately in a number of standard normal sampling and de-spin mode combinations. Up to the present time, this data has not been available to the Cluster community. We present results here comparing the performance of the on-board de-spin algorithm versus the normal sampling modes over a number of boundary layer crossings, describe the techniques used for calibration and timeline recovery, and outline the context in which the data may be usable in future studies.     

Results from the ESA SREM monitors and comparison with existing radiation belt models

The Standard Radiation Environment Monitor (SREM) is a simple particle detector developed for wide application on ESA satellites. It measures high-energy protons and electrons of the space environment with a 20° angular resolution and limited spectral information. Of the ten SREMs that have been manufactured, four have so far flown. The first model on STRV-1c functioned well until an early spacecraft failure. The other three are on-board, the ESA spacecraft INTEGRAL, ROSETTA and PROBA-1. Another model is flying on GIOVE-B, launched in April 2008 with three L-2 science missions to follow: both Herschel and Planck in 2008, and GAIA in 2011). The diverse orbits of these spacecraft and the common calibration of the monitors provides a unique dataset covering a wide range of B-L* space, providing a direct comparison of the radiation levels in the belts at different locations, and the effects of geomagnetic shielding. Data from the PROBA/SREM and INTEGRAL/IREM are compared with existing radiation belt models.     

Soft X-ray characteristics of white dwarfs observed by EXOSAT

EXOSAT has observed 19 hot white dwarfs with alleged strong soft X-ray emission. Positive detection of a large fraction of this sample was obtained, among these practically all hot DA dwarfs. High-resolution spectral data, acquired with the 500 1/mm grating spectrometer, indicates no traces of He in the atmosphere of HZ43, i.e. n(He)/n(H) ? 10^?5 at a photospheric temperature of 60000 K (log g = 8). In contrast, the hot DA1 dwarf Feige 24 shows the presence of an appreciable He-abundance (n(He)/n(H) ? 10^?3); however no simple homogeneously mixed H/He atmosphere can explain the observed spectral shape.     

LMC X-4: 13.5 s pulsations and an X-ray flare observed by EXOSAT

EXOSAT observed LMC X-4 on November 17/19, 1983 for one 1.4 day binary period during the high state of the 30.5 day cycle. An eclipse with sharp ingress and slow egress was detected with an eclipse angle of 27.1±1.0 dgr. In the medium energy experiment the source showed a hard power law spectrum. Outside eclipse the source was remarkably constant and only one flare was detected on November 17 at 19 UT lasting for about 1 h. The energy spectrum of the source softens considerably during that time and shows an emission line of cold iron. 13.5 sec pulsations are strongly present during the flare and have also been detected during the quiescent period and during several 1 min flares in another EXOSAT LMC X-4 observation on November 22, 1983. A pulse delay time analysis results in the determination of the pulse period (13.5019±0.0002) s and of the semimajor axis of the orbit of the X-ray star (26.0±0.6) It-sec. These results, together with other available information on LMC X-4, allowed to improve the binary parameters. The mass of the neutron star is found to be 1.34 _±0.44 ^0.48 M_o (95% confidence errors).     

On small active region filaments,fibrils and surges

High resolution Hα images and magnetograms (0.2 arc s) of an active region were obtained in alternating time series at 42 s cadences using the Swedish 1-m Solar Telescope on 2004 August 21. The Hα filtergrams reveal an active region filament and surges consisting of thread-like structures which have widths similar to the widths of chromospheric fibrils, both recorded down to the resolution limit in the best images. All observed structures in the active region appear highly dynamic. Fibrils show counterstreaming strongly resembling the counterstreaming threads in filaments.     

Nondestructive testing of honeycomb structures by computerized,thermographic systems

Complex honeycomb space structures (i.e. antennas, solar panels, etc.) must be inspected and accurately tested before flight.The thermography can be employed with success for the detection of the position of defects (delaminations, noneffective bondings, cracks, etc.) and for the evaluation of their size and geometry in all the cases in which the defect acts as a thermal resistance due to the low conductivity of the air filling the defect volume.The basic idea is to create in the specimen a heat flow distribution that is altered by the presence of the defect.The surface temperature distribution is then measured by means of a thermograph and is correlated with the presence of the defect.A numerical analysis and preliminary experiments have been carried out which show the feasibility of the method as applied to honeycomb structures.